skyeye运行实例详解.docxVIP

最简单的可以在skyeye上运行的程序!?介绍：初始学习嵌入式系统编程和使用Skyeye的人往往不知道该如何入手，?我想除了看资料以外，最好还有简单的例子可以用来作为基础练习。一般学习新?的编程和工具，都是从helloworld入手，所以我参考ucos-ii，使得用最少的代码?实现在skyeye上打印helloworld字串的功能。注意这里的Hello4Skyeye程?序与以前介绍的skyeye上的helloworld程序不同：它不需要有操作系统底层支?持，比如uclinux；它不是应用程序；它直接往串口写字符。Hello4Skyeye代?码量很少，没有实际应用意义，只是新手用于练习使用，高手就不必看了，欢迎?检查。?编译运行： Hello4Skyeye程序是在Skyeye0.8.6，RedHat9.0上编译?通过的。编译之前请确定安装了Skyeye和arm-elf交叉编译器。有关这两者的安?装说明可以在论坛置顶的《Skyeye使用简介》中找到。步骤如下：?1 把Hello4Skyeye.tgz下载到Linux用户目录中用?tar -zxvf Hello4Skyeye.tgz 解压缩Hello4Skyeye.tgz, 产生?Hello4Skyeye目录?2 cd Hello4Skyeye?3 用make编译?4 用skyeye hello运行hello，和其它程序一样接着用tar sim； load；run；?就可以看到以下结果：?引用:***************************************************************?**** ****?**** SkyEye Simulator Ver 0.8.6 with GDB 5.3 Interface ****?**** ****?***************************************************************?GNU gdb 5.3?Copyright 2002 Free Software Foundation, Inc.?GDB is free software, covered by the GNU General Public License, and you are?welcome to change it and/or distribute copies of it under certain conditions.?Type show copying to see the conditions.?There is absolutely no warranty for GDB. Type show warranty for details.?This SkyEye was configured as --host=i686-pc-linux-gnu --?target=arm-elf...(no debugging symbols found)...?(SkyEye) tar s?cpu info: armv3, arm7tdmi, fff8ff00, 0?mach info: name at91, mach_init addr 0x813dae4?log_info: log is off.?log_info:log file is /tmp/sk1.log, fd is 0x829e0e0?log_info: log start clock 0?log_info: log end clock 200000?SKYEYE: use arm7100 mmu ops?Connected to the simulator.?(SkyEye) load?Loading section .text, size 0x98 vma 0x1000000?Loading section .data, size 0x1000 vma 0x1002000?Start address 0x1000000?Transfer rate: 33984 bits in 1 sec.?(SkyEye) run?Starting program: /home/shang/HelloForSkyeye/hello?helloworldhelloworldhelloworldhelloworldhelloworldhelloworld?helloworldhelloworldhelloworldhelloworldhelloworldhelloworld?helloworldhelloworldhelloworldhelloworld组成部分：在Hello4Skyeye目录中用make clean命令