高级工复习题（Advanced rehabilitation exercises）.docVIP

高级工复习题（Advanced rehabilitation exercises） This article is contributed by liDOC documents may experience poor browsing on the WAP side. It is recommended that you first select TXT, or download the source file to the local view. Choose a correct answer. First, individual choice questions (first questions ~ eightieth questions). Choose a correct answer and put the corresponding letters into the brackets in the questions. 1 points per game, 80 points. 1. discipline is also a code of conduct, but it is a special norm between law and (). A, regulation, B, ethics, C, system, D, specification 2., transmission output shaft (), tightening torque is 100 N ? M. A, screws, B, nuts, C, bolts, D, any axis 3. () meaning include: collective consciousness and cooperation ability two aspects. A, collective force B, behavior regulation C, team consciousness, D, standard consciousness, 4. starter for no-load test, if the starter assembly is too tight, then (). A, high current, low speed, B, high speed and low current, C, current speed is high, D, current, speed is low, 5., starter starter control line is mainly responsible for the starter () power supply. A, armature winding, B, magnetic field winding C, electromagnetic switch D, relay 6., freon, R12 and water. A, the solubility is larger, B and solubility is smaller, C, any proportion of each other dissolve D and can not be solved, the 7. transmission housing front and rear facing the first, second axis bearing hole common axis of the round run error, can be () for testing. Do not move to A, B, C, dial micrometer, height vernier caliper D 8. blower (cause) feeler. A, not refrigeration, B, air conditioning less than C, the system is too cold, D, noise 9., for piston reciprocating four stroke engine, complete a work cycle, crankshaft rotation () ring. A, 1/2, B, 1 C, 2 D and 410. transmission input shaft front spline teeth wear shall be no greater than () mm. A, 0.10, B, 0.20, C, 0.30, D, 0.60, 11. charge the battery discharged