大连海洋渔业集团港口改扩建工程港口航道与海岸工程.docVIP

大连理工大学本科毕业设计 辽宁省大连海洋渔业集团港口改扩建工程 学??院（系）：土木水利学院???????????? 专??????????????业：港口航道与海岸工程 大连理工大学 ??????????????????????????????? 摘????要 本设计的任务是新建突堤式客货滚装码头，码头呈凸字型。将原滚装区突堤两侧分别向内凹进（布置升降桥），顺原方向建????长、???宽的突堤，突堤两侧形成???????滚装泊位各一个。 本工程是在现有港口基础上的扩建工程，现有航道的宽深均满足万吨级轮船的航行要求。供水，供电及运输能力也都有一定的基础，且港口供水电能力富裕很大，能满足扩建后新增两个滚装泊位的用水用电要求，水、电供应不需要新增，经过核算，只需要新建一处?????平米停车场。经过地质、气象条件分析及方案比选，选择了沉箱重力式结构码头，码头顶标高???米，底标高????米。此工程共需??个沉箱，每个沉箱长????米，宽???米，高???米，加?米深水时能满足浮游稳定性要求。胸墙采用?形，???素混凝土，高???米，底宽?米，上部高???米，宽?米。基床采用混合式形式，厚????米，前后肩各宽?米，坡度?：???。 按照《港口工程设计手册》计算结果表明，胸墙，沉箱都满足抗倾抗滑稳定性验算，地基承载力也满足要求。 关键词：滚装码头；扩建；万吨级；港口工程；稳定性 ??????????? Abstract The task of this project is to design a new passenger and freight Ro-Ro jetty type terminal, this Terminal was protruding .The original area of the Ro-Ro jetty on both sides of the respective recessed inward 30m (for layoutting the lift), Along the original direction of which we will build 192m long, 89m wide jetty, to form two berths on both sides of the jetty of a 10000GT. The project is an expansion project based on the existing port. The existing Fairway are wide-deep enough to meet the requirements of navigation of 10,000-ton vessels. Water, electricity and transport capacity are also the basis of a certain and well-off port for a large hydropower capacity, to meet the expansion of two new ro-ro berths after the water consumption requirements. water and electricity do not need to add. After accounting, only a new 10,000 square meter parking need to be built. After geology, weather conditions and plan selection, I choose the structure of the jetty gravity caisson pier, pier top elevation is 5.2 m, -7.2 m elevation at the end. The project total of 15 caissons, each caisson 12.8 meters long, 9.3 meters wide, 9.8 meters high. plussing 1 m deep water when floating stability of the requirements to meet. The use of L-shaped parapet, C25 plain concrete, 2.8 meters high,The end is 4 meters wide, the upper 1.5 meters high, 2 meters wide. Bed-based is hybrid-type.