空压机1（Air compressor 1）.doc

空压机1（Air compressor 1） Abstract: high exhaust temperature is the temperature rise fault caused by various problems in the air compressor. Air compressor in operation if not enough lubrication or cooling, will make the body in high temperature, long time work. But the high temperature will reduce the gas transmission coefficient and the power consumption is increased, the viscosity of lubricating oil can be reduced, the high temperature also makes the Department of physics of rotor and bearing material numerical changes, causes abnormal friction loss of bearings, bearing beads and even accidents, high temperature will make the lubricating oil in the thermal decomposition of metal under the catalysis of work generated harmful free carbon, acid and water (carbon), which will make the whole screw stuck or stopped jumping phenomenon, affecting the normal production of enterprises. Key words: air compressor; high exhaust temperature; troubleshooting; cooling transformation Preface An air compressor is a mechanical device for compressing gases. The compression of gas depends on the change of the volume, and the change of the volume is achieved by the rotation of a pair of rotors of the compressor in the casing. After the air is compressed, that is, the air has done the work, the temperature must rise, and then passed through the heat transfer to the cylinder, the cylinder heating, overheating will appear, the exhaust air temperature exceeds the prescribed value. But too high temperature will make the Department of physics in the body of rotor and bearing material numerical changes, serious will appear to stop the entire host locking phenomenon, although air compressor manufacturers are on the installation of a high temperature protection device, but also can make the existing fault protection device acts frequently, affect the normal production of enterprises. I use the factory in 1998 introduced 3 sets of Corning screw air compressor, model DSR-10A, power 17 5KW, gas supp