空压机故障排除（Troubleshooting of air compressor）.doc

空压机故障排除（Troubleshooting of air compressor） Cannot start 1. failure phenomena and possible causes Troubleshooting method The power is not connected; Close the power switch to turn on the power. Control circuit fuse fuse; Replace the fuse, find out the cause and solve it. Exhaust temperature is too high to cause high temperature shutdown According to the exhaust temperature is too high or oil temperature is too high section to solve, and then restart the compressor. Thermal overload relay is disconnected; Correct the overload reason and reset the thermal overload device. Voltage is too low; Please check the input voltage with the power department and compare with the motor terminal voltage. To check the cause of the voltage is too low. Power failure; Check the power supply section. Loose wiring; Check all wiring endpoints and fasten them. Temperature sensor fault; Check sensors and contact maintenance with professionals. Transformer fault; Check secondary voltage of transformer. Unexpected stop Failure phenomena and possible causes Troubleshooting method Exhaust temperature is too high; According to the exhaust temperature or oil injection temperature is too high part of the content processing. Then restart the machine. Power failure; Check the power supply section. High temperature switch fault; Contact the operation and maintenance personnel. Loose wiring; Check all wiring endpoints and fasten them. Thermal overload relay is disconnected Failure phenomena and possible causes Troubleshooting method Exhaust pressure is too high; Lower the unloading pressure a little. Voltage is too low; Check the input voltage and current at full load. The thermal overload relay is loose; Tighten connection screw for thermal overload relay. The thermal overload relay is not set properly; Check motor nameplate and compare with overload relay setting. Motor or starter wiring is loose; Check all connections for tightening. Motor fault; The motor and starter wiring shall be checked before