光码标签交换网络边缘节点FEC的研究StudyofFECatedgenodeof.PDF

第33 卷第5 期 通 信 学 报 Vol.33 No. 5 2012 年5 月 Journa l on Communications May 2012 光码标签交换网络边缘节点FEC 的研究 王玉宝，纸少瑜 （燕山大学信息科学工程学院，河北秦皇岛066004 ） 摘 要：构建了光码标签交换网边缘节点的 结构，结合光码分复用技术提出了转发等价类（FEC ）分组结构的设 计方案。分组结构适合变长数据分组的传输，在核心节点能够实现对标签信息的可并行处理，提高了处理效率。 在此基础上，针对开销比对网络传输性能的影响，对FEC 结构中的各参量与开销比的关系进行了仿真研究；采用 了固定时隙算法对数据分组进行封装，对到达率和封装时延与分组丢失率的关系进行仿真分析。 关键词：边缘节点；业务汇聚；封装时隙；转发等价类；开销比；分组丢失率 中图分类号：TN913.7 文献标识码：A 文章编号：1000-436X(2012)05-0072-07 Study of FEC at edge node of optical code label switching network WANG Yu-bao, ZHI Shao-yu (School of Information Science and Engineering, Yansha n University, Qinhuangdao 066004, China) Abstract: The structure block of the optical code label switching network was built, and the design scheme for the for- warding equivalent classes (FEC) was proposed employing OCDM technology which was appropriate for variable pack- ets transmission and allow the label processed in parallel in core node. The overhead between the duration of control bits and the duration of payload was investigated based on the above design scheme. The fixed slot algorithm (FSA) was em- ployed to assemble the incoming packets in the assemble queue, simulation results and analysis were given between the relation of arrival ratio/assemble slot and packets loss ratio. Key words: edge node; traffic aggregation; assemble slot; forwarding equivalent classes; overhead ratio; packet loss ratio 技术在分组标签交换中的引入，充分利用了波长的 1 引言