自来水scada（自来水scada）.docVIP

自来水scada（自来水scada） Ms. lock Jun, engineer of Technology Development Department, information center of Shijiazhuang water supply general company. Keywords: process graphics Wizcon SCADA system trend curve database support network released a SCADA water system structure and key points in the SCADA system in water plant, Wizcon as configuration software, and field control equipment such as PLC, RTU, remote terminal unit of measurement instruments and other equipment connected. The Wizcon receives data from the monitoring device and processes it accordingly according to system logic requirements or operator requests. This paper takes Shijiazhuang as an example to introduce the SCADA water system. 1. SCADA water system structure principle of SCADA system in Waterworks water production process, can use reasonable medicament according to the water quality change; according to the pipe network pressure and water level changes, water regulation, flow rate, pump group etc.. At the same time, the plant operating conditions, operating parameters and water quality parameters such as real-time to the dispatch room, computer based data analysis, reflect the state of water supply from different angles, including network load analysis, water supply, plant water path query point, network flow dynamic pressure distribution, flow direction simulation, so as to optimize the dispatching mode. Figure 1 for the system structure principle diagram, including 9 sites, 1~7 water plant site structure is simple, 8 water plant site structure is more complex, omit a pressure station site. 2. SCADA water system analysis of the key (1) remote terminal unit RTU: the whole network in each subordinate work site has a RTU, it sets the data sampling and communication functions, the data collected from the field, transferred to the scene and the dispatch center computer, Wizcon configuration processing. (2) communication protocol: the data of each sub station is transmitted by Modbus and SY/NET protocol.