薄膜脱气（Membrane degassing）.docVIP

薄膜脱气（Membrane degassing） Application of resin encapsulation technology in automobile industry and electronic industry in China Tianjin University, Hong Bin Abstract: with the rapid development of Chinas automobile industry and electronic industry, the demand for resin sealing material has also increased considerably The quality of long and potting materials is also increasing. The use of MMD (Meter Mix Dispense), that is, metering mixed dispensing technology is gradually Applied to the automotive industry and the electronics industry, we have applied the H series of sealing equipment to the MMD technology at the Tianjin University wave company Make a brief introduction. Keywords: resin sealing technology, potting material MMD (Meter, Mix, Dispense) Two component resins, including epoxy resins, polyurethanes and silicone resins, have been used as high strength sealing insulating materials for electronic and electrical equipment More than thirty years of history, it can not only play an electrical insulation effect, but also be used as supporting structural materials, while waterproof, moisture-proof, Corrosion resistance, cold resistance, heat resistance, impact resistance and excellent properties such as seismic. With the rapid development of Chinas automobile industry and electronics industry, The demand for resin sealing material also increases greatly, and the quality of potting compound is increasing day by day. Listed below in the automotive and electronics industries More prominent use of potting materials in the field: Automotive Industry: ignition coil, sensor, igniter, voltage regulator, motor, ECU and so on Electrical and electronic industry: transformers, high voltage insulation components, sensors, electronic transformers, line output transformers (FBT), Controller, etc. Two component resins are used as potting materials for electronic and electrical equipment. Various additives, such as fillers, pigments, toughening agents and curing agents, are added A