装饰工程说明（Decoration engineering description）.doc

装饰工程说明（Decoration engineering description） Explain A general description of the 1. this chapter of mortar types, mix ratio, finishes materials and profiles specifications, models, such as design requirements are not the same, can be adjusted, artificial, mechanical unchanged. The 2. plastering project in this chapter, plastering is made by ordinary plastering. If the design for senior plastering, according to the corresponding item of manual and mechanical multiplied by the coefficient 1.2, multiplied by the coefficient 1.3. The In this chapter, with 3. plaster paste block base leveling plastering, not including cement paste, building glue brush mud, interface (processing) agent, such as the design requirements, according to the corresponding item execution. The The 4. chapter in the column and wall and ceiling ceiling are prepared respectively according to the list of keel, the grass surface, when used according to the design, and execute according to the corresponding item. The The 5. chapter keel (skeleton) type, spacing, specifications and grass surface material specifications and models according to common materials and Practice for development, such as design rules at the same time, material and material consumption can be adjusted, the other unchanged. The 6. the section or thickness of the wood indicated in this chapter shall be based on the gross cross section. If the design requirement is that the section or thickness of the wood is a net material, the planed loss shall be increased. One side, the planed light increases by 3mm, and the double side planed light increases by 5mm. The The 7. chapter, base board do not include keel brush fire retardant coating (fire retardant paint), such as the design requirements, according to the corresponding item execution. The 8. in this chapter, the cost of amortization of simple scaffolding under 3.6m shall be included. The Decorative surface layer 9. in this chapter does not include all kinds of decorative lines, such