踏板车（Scooter）.doc

踏板车（Scooter） Satisfactory rate: 100% Motorcycle engine operation in the process of overheating mainly due to the following: 1, the new car or new overhaul of the engine in the running period of high-speed, high-power operation; New or new engine overhaul, due to a smaller gap parts assembly, component surface finish is poor, need a period of running in order to achieve the ideal clearance and finish, if in the running period of engine high speed or heavy load operation, will make all parts of the engine under high load, wear increase mechanical cooling efficiency, and the engine oil will also appear due to withstand high temperature oxidation, early metamorphic engine oil also affect parts of the lubrication and friction reducing effect, there will be severe oil into asphalt. If the engine temperature is too high, the early scuffing, burning tile and axle malignant mechanical fault will be serious. Therefore, the running law must be followed when the motorcycle is in the grinding period. (1) the running mileage of the new car shall be carried out in accordance with the regulations on the use and maintenance of the new car. Running in period is generally divided into two stages, the first stage is 0~500km, and the second stage is 500~1500km. (two) during the running in period, the higher the vehicle speed is, the greater the load of the engine and the driving mechanism, so the new car or the large vehicle must strictly control the speed of running during the running in period. We have 125 series of motorcycle as an example, the period of the new speed limit is defined as: in the first stage during running in gear speed should be controlled in a block respectively: 20km/h, 25km/h, two block three block 35km/h, block four, block five 40km/h 45km/h; in the second stage during running in gear speed control in 25km/h, 30km/h, 40km/h, 45km/h, 50km/h. (three) matters needing attention (1) load reduction: the running capacity of the vehicle during the running in period shall