通力3000故障代码（Kone 3000 fault code）.doc

通力3000故障代码（Kone 3000 fault code） Kone 3000 fault code Code Fault name Reason Operate Recover Test 0001 Long drive time The position signal 30/B30 does not change after a period of running time. Immediate stop Turn off the electricity Slow the elevator stopped under 77:U, unplug the 0.61:U/N, to express 0004 Three consecutive simultaneous failures 3 consecutive simultaneous operation, can not receive the correct 77:U/N, 61U/N, 30 signals After 3 failures, stop at the terminal Turn off the electricity - 0007 The gate signal 30/B30 is jammed After starting a period of time, the falling edge of the 30/B30 signal is not detected, and the gate signal 30/B30 is always valid Run to the goal floor and open the door Power off or repair The 30 (B30) signal on the shorted LCECCB (XB24), the lowest pin of the -XB21 0008 NVRAM damage or capacity is not enough When power is transmitted, the capacity of NVRAM is not enough - change the NVRAM - 0014 The gate area monitoring circuit is not released Any one of the 486443:1443:2 has no pull in 2 consecutive runs Run to destination layer out of service Turn off the electricity Runtime makes 443:2 (LCEADO) not pull in 0015 The gate monitoring circuit is not attracted Any one of the 486443:1443:2 is not released in 2 consecutive runs The runtime keeps 443:2 (LCEADO) in hold 0021 The safety loop is blocked Safety loop input 1 no voltage Immediate stop Safety loop connection Disconnect the safety circuit 0022 The running well lock is disconnected Safety loop input 3 no voltage Immediate stop Lock on hoistway door Use the key to open the hall door or unplug the LCE230 XH2 0023 The door lock is broken at the time of operation Safety loop input 2 no voltage Immediate stop Car door lock - 0025 Boot enable fault When the elevator stops, the main contactor is not released Not started Main contactor release Keep 201:1 or 201:2 or 204 all the time 0026 The drive system is out of order The drive system detected a fault (V3F, OK, lights are not lit)