锅炉汽包吊装（Boiler drum hoisting）.docVIP

锅炉汽包吊装（Boiler drum hoisting） (two) scheme analysis 1, translation scheme Scenario 1: Just above the use of rope hanging on the drum in advance temporary position, when the drum up to the highest point, the wire rope drum and temporary suspension lug connection, slowly descend winch, the temporary wire rope slowly using their own weight bearing, eventually swung to a position in the drum. The biggest advantage of this scheme is that there is no need to design temporary facilities to save costs, but accurate calculation of the length of the suspension rope, otherwise, the drum will not be in place smoothly. At the same time, because the drum in the process will produce tension to the entire boom beam, it is easy to cause the deformation of the boom beam, which will affect the installation quality of the drum after placing in place. Scenario two: Laying the slipway, designing and making small tanks to slide them on the slipway. When the drum is raised to a certain height, the chain pulley is used to pull forward the root of the fixed pulley, and the small tank and slideway are used to slide the drum into position. This scheme is more complicated than the scheme one, but its advantage lies in the steady process of the drum in place, the random adjustment of the drum position and the steady position of the drum. After discussion by the panel members, the final decision was made on programme two: laying the chute and using small tanks. Choose the scheme that the winch is arranged at the bottom of the furnace. (two) determine the best plan Through the above analysis, we have chosen to solve the drum tilt 40 degrees lifting and moving at a certain height 4 meters in place of the best program. The winch arranged in the bottom, put 200 tons of pulleys to install small tanks in the fixed pulley deep beams, a small tank chute arranged outside the drum boom beam, 40 degree tilt lifting in close to the H beam, the drum height more than 54 meters after leveling, by pulling a small