隔离刀闸的故障处理（Fault treatment of Disconnector）.docVIP

隔离刀闸的故障处理（Fault treatment of Disconnector） Fault treatment of Disconnector 1. the isolating knife can not be pulled or closed. When the switch is pulled open or not, as a result of the operating mechanism is blocked, it should be a little shake, then pay attention to each part of the support insulator and the operating mechanism, according to the situation and change their deformation, find the resistance spot. 2. isolating knife contact parts heating The heating of the contact part of the isolator is due to the loosening of the pressed spring or bolt and the oxidation of the surface, which usually develops very quickly. Because of the influence of heat, the surface of the contact part is more easily oxidized, so that the resistance increases and the temperature increases. If it continues to develop, arcing may occur and then become a ground fault. When the 2.1. double bus line is connected, the heating isolating knife switch must be shifted off. That is to use the circuit breaker to transfer the load, transfer the load of the heat isolating knife switch to the isolating knife switch of the reserve bus side, and then send the heating isolating knife out of operation. When the 2.2. line isolation knife is hot, the heating isolating knife can be operated, but it needs to be strengthened until the power failure can be checked and repaired. If the conditions permit, you should try to run by road instead. With the rapid development of our national economy and the continuous improvement of peoples material and cultural living standards, the demand for electric energy of power consumers is becoming larger and larger, and the quality of power supply is becoming higher and higher. Due to the rapid development of electronic and micro electronics technology, in order to ensure the quality of power supply, the security, reliability and economy of power system operation are guaranteed. According to the actual situation of Chinas current, can use the technology now can be a numbe