汽车中控（Automobile central control）.docVIP

汽车中控（Automobile central control） A lock, triggering method and connection: A. negative trigger judgment: clamp end ground test pen. Two control lines end touch stylus test lock, if the lock, the two line is a negative trigger control line lock. B. is the method of judging the trigger: test pen clamp end is connected with the power supply, and two control line end touch stylus lock, if the lock, the two line is a line trigger master lock. C. positive and negative trigger judgment: if using the above two ways to judge the lock is made, which is positive and negative trigger mode, sometimes sleeping! Emergency shoes always on tenterhooks!! throw is spilled!. D. series single negative trigger judgment: with only one test pencil line lock, then find no lock line, and cut the line will unlock. E. positive and negative trigger and positive loop judgment are the same, some people say. A positive or negative trigger does not necessarily have a positive loop. They judge the way to unlock or lock the lock, there are two with a positive line, disconnect the two can be positive and negative trigger, but not necessarily with positive loop. In the break line, and give a positive lock separation, then look at the lock is not open or closed, it is concluded that the loop is not positive. F. double potential trigger: he is on the same line will have two action at a time of high voltage and low voltage (shidianbi clip negative, a test in the control box, if a line up on or off, meet again, showing off or on, there are two potential negative contact) G. single line negative triggering (the method of judging is repeated action on the same line, giving a power to move once) H. single line series negative trigger and single line negative trigger difference is big, single line series negative trigger is to disconnect the central control line, to the host power supply and positive loop power supply, instead of single line negative trigger, Two (single line series negative trigger method, fi