汽轮机试运行（Steam turbine test run）.docVIP

汽轮机试运行（Steam turbine test run） Complete start-up and commissioning of steam turbine The whole set of start-up and commissioning of turbo generator sets is the final test of equipment before being put into production, and it is also a comprehensive appraisal of equipment and installation quality. 1. test run and steam pipe flushing 1.1 water pump section commissioning and plumbing system flushing 1.1.1 rotating machinery segment trial run After the 1.1.1.1 equipment is installed, the motor is tested on an empty load. After determining the direction of rotation, the test should be switched from 1 to 2H. When the equipment vibration and bearing temperature rise are normal, stop, turn the motor and pump body alignment, and then connect the coupling bolts. 1.1.1.2 water pump and other rotating machinery division before the trial, the first test of the system concerned, only after the test pressure qualified, the system must be tested flushing. 1.1.1.3 water quality requirements and higher precision rotating machinery, such as various types of pumps, their entrance should be equipped with filters, in order to prevent debris access to damage equipment. Before the 1.1.1.4 test, the bearings of the rotating machinery should be cleaned up, and the qualified lubricating oil or grease will be added, and the rotor will be driven. Only after confirming that everything is normal shall we start the rotating machinery. 1.1.1.5 pump or other rotating machinery, according to the provisions of load trial operation, the general provisions of not less than 4 ~ 8h, in response to the trial operation of bearing vibration and oil temperature rise, pump entrance pressure and motor current and temperature monitoring and recording. Only when the above record conforms to the technical requirements can the branch be proved to be qualified. 1.1.1.6 according to the design requirements to do the protection and linkage test, should achieve the design of technical indicators. Flushing of 1.1.2 water