球磨机-说明（Ball mill - Description）.docVIP

球磨机-说明（Ball mill - Description） Gongyi Hongtong mine factory Lattice ball mill The end cover of a lattice ball mill with a hollow shaft at the ore discharging end is provided with a bearing inner sleeve and a discharge ore lattice. Discharge lattice by lattice center liner, liner and dustpan shaped lining board etc.. Cast ribs with eight radial wall in the end cover, the end cover is divided into eight fan-shaped room, installation of dustpan shaped lining board in each sector chamber, and fixed by the screws on the end cover, and then the grid plate is installed on each plate lining dustpan fan chamber formed on. Grid lining board has two forms: one is composed of two blocks of synthesis of a group, by wedge pressing, wedge iron screws through the fastening ribs on the end cover, a center of center liner spigot holds so they tilt and fall off; another is the synthesis of a two block direct, fixed with screw. The center liner is star shaped. It consists of two pieces and is fixed to the bars by screws. Main use of lattice ball mill Widely used in cement, silicate products, new building materials, refractory materials, fertilizers, black and non-ferrous metal processing, glass and ceramics and other production industries Working principle of lattice ball mill The hole on the lattice lining plate is inclined and the width of the hole is gradually extended to the ore discharging end, so that the slurry backflow and the clogging of the coarse particles can be prevented. At the bottom of the ore discharge, the ore pulp flows into the fan chamber through the pores on the lattice lining board, and then goes to the upper part with the barrel and is discharged along the hole. The inner shaft of the hollow shaft is provided with a wear-resistant inner sleeve, and one end is made into a trumpet shaped blade, so as to guide the pulp to flow out of the mill along the vanes. Because the mill ore pulp is discharged through the grid plate ore discharging device. Advantages of latti