直板设计模块（Monoblock design module）.docVIP

直板设计模块（Monoblock design module） AB shell, middle frame, battery shell and other big pieces, all plastic Parting surface The clearance between 1 and AB shells is 0. 2, do not go in line under the condition of divided curved surface and sub surface normal angle must be greater than or equal to 3 degrees, can be 0 degrees, will die. 3, inside a draft of not less than 2 degrees 3, the enclosure around the ID does not require special, parting line should not fillet and bevel 4, when the shell folding parts, if later may scrape hands, must do art trough (0.3*0.3) Two, straight mouth 1, straight mouth size high 0.6MM width 0.6MM, straight mouth thickness direction gap 0.05, circumferential gap 0.05 draft, greater than or equal to 1 degrees, Three 、 screw, nut, screw plug and casing 1, general hot melt copper nut adopts: outer diameter 2.3, length 3, thread M1.4, length minimum 2, Hot stud, outer diameter 3.8, inner diameter 2.1, A stud with a diameter of 2.3 and a height of 0.30, for overflow 2, in limited space, copper nut with outer diameter 2.3, length 3, thread M1.4, length minimum 2, Hot stud, outer diameter 3.5, inner diameter 1.8, A stud with a diameter of 2 and a height of 0.30, for overflow 3, screw M1.4, screw head diameter 2.5, head thickness 0.8, length depending on the structure, as much as possible with the copper nut, 4. The clearance between the bottom of the shell stud and the copper nut is more than 0.25. It is used for overflow 5, shell screw head sink, internal diameter 3, outer diameter 4.5, screw hole 1.6, screw head pressing, plastic thickness is guaranteed at 1.2, to prevent locking plastic, The inner diameter shall not be less than 2.8MM 6, screw plug, and a clearance of 0, and the screw head clearance of 0. The design should pay attention to protection, intermediate screw plugs to be emptied, the wall thickness is above 0.8, the screw plug design, from the screw head about 2.0MM in diameter shrinkage 0.1MM, inner shrinking surface to draft, this s