直流均流电源指导教师钟洪声崔红玲杨忠孝队员及年级张林2006级.pdfVIP

直流均流电源直流均流电源 直流均流电源直流均流电源 指导教师：钟洪声 崔红玲 杨忠孝 队员及年级：张林2006 级 管锐 2006 级 黄柯 2006 级 学校及院系：电子科技大学 微电子与固体电子学院 摘要摘要: : 系统采用开关电源芯片 TPS5430 为核心制作两路稳压电源.两路电源 摘要摘要: : 可独立、并联使用。两路电源并联时，利用电流反馈控制技术，通过运放的动态 调节实现自动均流。采用超低功耗单片机MSP430FG4618作为系统主控制电路。 系统输出电压在 4.5V～5.5V之间连续可调；两路电源并联，在满载时,电流 差低于 0.1%；单路、双路并联时工作效率可达 90%；满载时纹波均低于 15mV； 具有过流保护，无线电发射、接受模块，实现报警功能，故障解除后电路自动恢 复正常工作；系统具有液晶实时显示电流、环境温度、时间等功能。 关键词关键词：：电流反馈，MSP430FG4618，TPS5430 关键词关键词：： Abstract：Abstract：Switching power supply system is based on TPS5430, a TI AbstractAbstract：： switching power supply chip. This system has two independent power supply, which enables it to work independently and parallelly. When in parallel, it uses operational amplifier to reach the goal of adjusting the load current automatically. It adopts the low-costing MSP430FG4618(an MCU) to be the main control part of the system. The output voltage of this power supply can be adjusted between 4.5V and 5.5V constantly.When working in parallel, it can reach the functions as below. The difference between the current is below 0.1%(full load). The efficient can reach 90% when working either indepently or in parallel. And the output ripple is below 15mV(full load). In addition, the system has the functions of over current protection, radio emission and receiver module, which can warn people if there is an emergency. Once the problem has been settled, the system can go back to normal automatically. This system has an LCD to