刻画大师（Portray master）.doc

刻画大师（Portray master） Look at this Carving master tutorial A new stroke, increase the manual function The operation method is as follows: 1. by]-[image file []-[] read read image an image file on the image 2. double-click the left mouse button, enter the node editor 3. press the node editor in [outline] button or press the A button, enter the state sequence of contour point the left mouse button to draw a curve. Double click the left mouse button, draw a straight line. Press the right mouse button to exit the state outline. Carving master 6.20 1. new function description using new elastic cutting function (semi cut function) 2. error correction A.) to correct some TIF image file in read a master carving black box is like. The two basic principle of drawing: The main purpose of 1. engraving machine is in the post forming text or graphics. Instant adhesive composition, by backing surface and two layers of material carving, special knife only in the post surface medium engraved text or graphics, and backing is not cut off. To ensure the quality of the carving knife special structure as shown in figure H, nose length, nose length can be adjusted, the ideal length should be adjusted to more than stickie surface layer thickness, and less than (surface + backing) thickness, engraving machine carving, the seat of the knife body protection tool sheath knife pressure in moderate conditions, can be carved through the sticky surface medium backing is not cut off. According to the feedback information of the market, using the method of adjusting the knife knife pressure to control the size of many customers in carving carving depth, the effect is not ideal. Use the correct method as mentioned above, by means of adjusting the carving depth control point. 2. because of the burin engraving machine can not take the initiative to rotate, and the knife blade must be cut in a straight line to work properly, so the design of the knife tip off knife center line distance, and the knife can