手机维修资料（Mobile maintenance information）.docVIP

手机维修资料（Mobile maintenance information） Mobile maintenance information (Rookie must see) Mobile phones, novices, data, maintenance Mobile maintenance information (Rookie must see) Mobile phones, novices, data, maintenance First, the boot small current 5-15MA or so (mainly because CPU does not work) ? clock circuits are not normal (13M and 32.768K) - voltage, AFC, frequency The clock crystal itself is damaged; - - replacement of crystals (mobile phone maintenance) The clock crystal produces a signal, but does not send it to the CPU; - - check the line between the crystal and the CPU Clock power supply is not normal (check power or crystal power supply tube) Reset voltage is not normal, mainly reset circuit work is not normal (check the power circuit or a separate reset tube) CPU the power supply is not normal, usually the power IC does not output the VCC voltage, or the power supply tube itself is not powered The CPU itself is damaged (direct replacement) Two, boot current of about 30-60MA (mainly the logic circuit work is not normal) The character line circuit is not working properly Power supply is abnormal Reset is abnormal (power on reset and power on reset) The chip is not normal Data line and address line are abnormal The font itself is corrupted (refers to the internal temporary storage of the font or the internal broken leg of the font) CPU damage (refers to CPU broken leg or controller damage, MOblink series CPU bad will have 80-150MA dead current) The program in the font is out of order. Three, boot large current (press the boot button current is much larger than the normal boot current, 200 - 600MA range) Is the main power supply load caused by the leakage of the boot current overhaul this kind of fault, to be familiar with or understand the motherboard circuit device function and power supply, these devices are usually in their next big capacitor, the capacitance of the power supply end is positive, reverse resistance capacitance anode circuit, you can kno