APN-35安装手册.DOC

 目录 简介 安全规范 APN-35 控制器特征 打开包装 概要 打开包装程序 货运指南 APN-35 硬件指南 AUS-12 电源箱 双APN-35 控制器安装法 DIP 跳线开关设置 与PC 间通讯线缆的接线方式 门磁接线方式 出门按钮接线方式 辅助输入的接线方式 读卡机接线方式 电锁接线方式 电锁稳压电路的安装 电锁中继输出接线方式 辅助中继输出接线方式 ASW-35 软件安装 PC主机系统的最低配置 光盘内容 软件安装  INTRODUCTION Safety Precautions A number of safety precautions appear in various paragraphs on the following pages. A summary of those precautions are repeated below for emphasis: WARNING High voltage, AC main power should only be connected by qualified, licensed electricians. All applicable laws and codes must be followed. If this precaution is not observed, personal injury or death could occur CAUTION If any damage to the shipment is noticed, a claim must be filed with the commercial carrier responsible. CAUTION Several important procedures should be followed to prevent electro-static discharge (ESD) damage to sensitive CMOS integrated circuits and modules. CAUTION All transport of electronic components, including completed reader assemblies, should be in static shield packaging and containers. CAUTION Handle all ESD sensitive components at an approved static controlled work station. These work stations consist of a desk mat, floor mat and a ESD wrist strap. Work stations are available from various vendors including the 3M company. WARNING Power should not be applied to the system until after the installation has been completed. If this precaution is not observed, personal injury or death could occur, and the equipment could be damaged beyond repair. WARNING Verify that the external circuit breaker which supplies power to the device power supply is turned off prior to installation. WARNING Verify that the output voltage of the power supply is within specifications prior to connection to the device. WARNING This equipment generates, uses, and can radiate radio frequency energy. If not installed and used in accordance with the installation and operating manuals, it may cause interference to radio communications. WARNING Operation of thi