质量要求2docaa.docVIP

一、 外观质量要求： 喷涂件表面的涂层平整光滑、均匀，不允许有皱纹、流痕、鼓泡、裂纹、露底、发粘等影响使用的缺陷。 A, appearance quality requirements: Spraying pieces of the surface coating, should smooth and even, Defects which influence the use, such as wrinkles, flow mark, blister, crack, tacky, and other defects are not allowed. 检验方法： 正常视力，在正常光线下，不使用放大器，将检验产品置于距离眼睛一个手臂远位置十秒钟内观察。 A 表面-产品安装后可以持续看到的表面。 B 表面-产品在安装前才能看到的表面。 Inspection method: Normal sight, under normal light, do not use amplifier, put the product in a arm distance position in ten seconds observation. A surface, the surface which can be seen continuously after installation. B surface, the surface only can be seen before installation. A面： 1．300mm长度范围内，只允许3个直径≤0.5mm的斑点、凹坑（不露底）、鼓泡等缺陷；超出记次要缺陷。允许有1条长度6mm且不露基材的划痕；6—20mm且不露基材的划痕记次要缺陷，超出20mm记主要缺陷。漏基材的划伤≤3mm不记缺陷；3—12mm长的划伤记次要缺陷；超过12mm的记主要缺陷。 A Surface 1.300 mm length, only allow no more than three spot, which less than or equal 0.5 mm in diameter, pits (dont show edge), blister etc. defect; if out off requirement ,sighed secondary defects. Allow one scratch, length 6 mm and do not expose base material; scratch, 6-20 mm length and do not expose base material sighed secondary defects, length over 20 mm sighed primary defects. Scratch, expose base material,less than or equal 3 mm, do not sigh the defects, 3-12 mm length scratches sigh secondary defects; length over 12 mm sigh the primary defects. 2．产品在手能碰到的地方无毛刺、利角，不允许有影响到客户安全的毛刺隐患存在。 Products may touch should no burr and no angle, other defects may lead to user injured are not allowed. 3．表面不允许有漏底现象。喷涂不均匀、一面厚，一面薄是不允许的。所有影响功能的缺陷都是不允许的：如：喷涂太厚或者大面积打腻子，影响附着力或影响装配；喷涂太薄，基材表面有麻点、凹坑，同时可能会生锈。 Surface are not allowed to expose edges. Spraying nonuniform ,one side thick while another side thin arent allowed. All of the defects which effect the function arent allowed ,too:For instance: Spraing too thick or widespread paint putty so effect adhesion or assemble;Spraing too thin ,there are pits on the base materials ,and may be rusted. 无安全隐患，如严重的裂缝、破损、焊接不良等。铁件与铁件之间的焊接牢固