位置传感器检修（Position sensor maintenance）.docVIP

位置传感器检修（Position sensor maintenance） 2009.1 (2) and Weichai Yuchai diesel engines Bosch common rail system when the engine crankshaft position sensor failure, can normal running and starting (limp home -Limp Home). Cause analysis: when the camshaft position sensor failure, in the starting process, only the crankshaft position sensor signal, when the missing teeth ECU detected signals of crankshaft position sensor, assume that the diesel engine in the first cylinder at TDC before, then according to the assumed angle phase, according to the work order for a certain number of times the fuel injection when the engine speed exceeds a certain threshold, the phase can be determined correctly, so as to judge the cylinder if no signs of success; speed increased, again assuming a phase (360 degree crank angle change of cylinder fuel injection), the starting process for a long time. But it will appear in the following situations: 2009.1 light fault light; the fault codes P0008, P00016, P0340, P0341, P0335 and P0336 related (depending on the specific circumstances, different); the starting time may be slightly longer than the normal condition; the throttle the vehicle running normal feeling; no obvious effect, but the fuel consumption and emissions may deteriorate. Special instructions: when the crankshaft position sensor and the camshaft position sensor are missing at the same time, the engine can not start. 2009.1 (3) 4F and 4W Yuchai diesel engines Delphi common rail system when the camshaft position sensor fails, the engine can not start and run. The following fault codes will be generated: P0341, P0335, P371, P372, P0336, and P0340. (4) Yuchai Delphi electronic unit pump system when the camshaft position sensor failure, the engine can be normal running and starting (limp home -Limp Home). 2009.1 project 2.1 position sensor maintenance (two) ECU treatment strategies and failure analysis of crankshaft position sensor maintenance: Lighting fault lamp, produce relevant fault c