raid分级（Raid classification）.docVIP

raid分级（Raid classification） RAID0 - RAID7 RAID0 provides parallel access (without redundancy) At least two plates RAID1 two disks, parallel interleaved, and mirrored one disk of data onto another disk. Utilization rate 50%. Faster than conventional mirrored discs. RAID3 uses a check plate to complete the fault tolerance. ? RAID5 does not have a special calibration disk, and the check data is distributed over a plurality of disks. When a disk fails, the controller can recover / generate lost data from other remaining disks without affecting the availability of data. Often used in I/O transactions more frequently. 3, the advantages of RAID High reliability. In addition to RAID0, fault tolerance techniques are employed at all levels. When a disk is damaged, data is not lost. Fast. Parallel access. Performance / price ratio. Large capacity fast memory using RAID technology, compared with the large disk system, the volume and price are both 1/3. Higher reliability ----------------------------------------------------------------------------------- RAUD0 turns multiple disks into one logical disk, mainly for extended capacity, RAID1, and two disks for hot backup. RAID5 requires at least 3 hard disks to verify each block and store the check information separately. Once the storage location of the original data is out of order, the missing information can be recovered by checking the information. The effective storage capacity of RAID5 is about 1/3.RAID10 of the total storage capacity of the disk, and it is used in combination with RAID0 and RAID1 , RAID 1: RAID 1 is also known as a mirror, because the data on the disk is completely copied to another disk. If a disk error occurred, or hard disk bad sectors, then another hard disk can interrupt the data loss and system failure caused the recovery back to disk. In addition, RAID 1 can also implement duplex - that is, you can copy the entire controller so that your data can be protected when disk failures or controller faults o