塑料注塑问题（Plastic injection problems）.docVIP

塑料注塑问题（Plastic injection problems） Plastic injection problems Applicable materials - Rigid grade: [general A and MA type] apply to 190 degrees below the processing conditions of hard plastic material, such as: GPPS, HIPS, BS (K glue) and so on. [high temperature B and MB] apply to the hard rubber material such as ABS, AS (SAN), PMMA (Acrylic) and so on for processing conditions above 200 degrees Celsius to 240 degrees celsius. Soft: suitable for PP.HDPE soft plastic [general P and MP] suitable for processing conditions below 210 degrees Celsius [high temperature E and ME] suitable for processing conditions between 220 and 250 degrees centigrade Addition rate Transparent effect: 0.5 ~ 1%, translucent effect: 1 ~ 1.5% Opacity effect: 2 to 4% Directions for use - 1, the first general processing conditions after the injection of finished products, and then adjust the operating conditions as the result. 2, if the product lines are too thin, the firing rate to speed up and reduce the processing temperature, and / or reduce the store feeding amount; on the other hand, if the masterbatch granular product show on there, then increase the processing temperature, and / or increase the store feeding amount. 3, the glue point (pour point) size will affect the grain thickness; so, enter the glue point is best not less than 1.3mm. 4, can be drying in rhyolite series masterbatch special requirements (drying), temperature is about 110 DEG to 120 DEG C, depending on the actual time and damp. 1, processing temperature: color masterbatch with rhyolite, please remember to start the cooling system of injection machine (water cooling system). If your injection model has 5 temperature settings, the temperature setting of the third, fourth, fifth segment must be the same. Injection products without effect (rhyolite said masterbatch has completely dissolved, so can not show the lines) please try, cut your processing temperature. 2, injection pressure (back pressure): start operation, the bac