智能控制在步进式加热炉温度自动控制中的应用毕业设计.docVIP

摘 要 在冶金行业中，步进式加热炉是轧钢生产线上的重要设备之一目前加热炉燃烧过程普遍存在能耗高、钢坯温度波动、温度控制精度等问题常规控制方法难以进行有效的控制论文针对步进式加热炉的工艺特点，分别采用传统的PID控制、模糊控制及多模态控制对加热炉燃烧过程进行控制其中模糊控制和多模态控制属于智能控制从而解决了PID控制存在的响应慢、超调量大的问题加热炉控制要求。 本论文采用MATLAB对PID控制模糊控制和多模态控制进行仿真，观察仿真结果，通过调参数全面改善系统的动态和静态性能使控制曲线关键词：步进式加热炉PID控制模糊控制多模态控制MATLAB The application of intelligengt control to temperature controlin walking beam furnace Abstract In the metallurgical industry, rolling mill reheating furnace is one of the important equipment in the production line, furnace combustion process is currently prevailing high energy consumption, It includes : non-linear; uncertainty, such as strong coupling, the furnace has a large delay, large inertia and time-varying characteristics, and interference factors which are relatively poor controllability of the object of a regulation. Furnace based on the reheating furnace of the above-mentioned characteristics, the conventional control method difficult to carry out effective control, the paper reheating furnace for the process characteristics, respectively, using the traditional PID control, fuzzy control and multi-mode control for furnace control the combustion process, intelligent control is based on the control of plant design experience, Their mode of thinking to imitate people, nonlinear and uncertain object model of the control object to control a very good effect, so as to solve the PID control and the existence of the traditional fuzzy control to respond to slow, large overshoot and to ensure control of the furnace to meet the practical requirements of production, In this paper, the use of MATLAB on the PID control, fuzzy control and control of multi-mode simulation, observe the simulation results, by adjusting the parameters of an overall improvement in system performance of both active and passive, idealized curve control, standardization. Key words: natural language processing; lexical semantic driven; structural disambiguation; machine tr