手提电脑外观检测标准.docVIP

外观检测标准 1.範圍: SCOPE 本文規範DESKTOP.手提式伺服器(SERVER)以及除了手提式產品 所使用之面板顯示器以及鍵盤等顯示功能產品以外之任何產品. This specification defines the COSMETIC requirements for DESKTOP , PORTABLE ,SERVER ANDOPTION PRODUCTS EXCLUDING DISPLAY SCC individual assembly drawing for cosmetic requirements for assemblies excluded herein. 2. 参考文件: PEFERENCE DOCUMENTS 2.1應用文件:下列文件為本規範的一部分.除非特別指定,否則文件以指 標或申請提案日為生效日期. APPLICAB LE DOCUMENT The following documents form a part to this specification to the extent Specified herein. Unless otherwise indicated, the documents is of the Issue if effect on the date of invitation to bid or request for proposal. 2.2.優先順序: ORDER OF PRECED 本文若與其製程管制項目相牴觸,則以製程管制項目為優先. In the event of a conflict between this document and the manufacturing process Details, The manufacturing process details shall take precedence. 本文若與其製程管制項目相牴觸,則以製程管制項目為優先. In the event of a conflict between this document, reference documents and piece Part drawings, the piece part drawings will take precedence. 3.檢視方法: INSPECTION METHOD 3.1.目視檢測: 依下列規定檢測. VISUAL INSPECTION Inspection shall be conducted as follows. 3.1.1.照明:目視檢測以工廠常態照明(100±20呎燭光之冷白螢照明光) 為宜. Lighting Visual inspection shall be conducted under normal shop lighting (100±20 Foot candles cool white fluorescent illumination). 3.1.2.位 置: position I.將待測零件置於執行檢測者面前18至24吋(約手臂長) place the assembly or piece part 18 to 24 inches (arms length) in front of person performing the inspection . II.應以正對檢測者及垂直於表面(即±45角度)兩方向進行零件組件 目視檢測. The assembly or piece part shall be viewed in two positions, normal to Inspector and perpendicular to the surface(±45 degrees). 3.2. 退貨標準 DEFINING REJECT CRITERIA 3.2.1直徑小於0.01英寸之任何瑕疵,視為看不見. Imperfections less than 0.01 inch in diameter are considered not Visible 3.2.2.必須依第3.1.2之II節所規定之兩方向都看得到才算缺點. The defect must be seen in both viewing position, see section 3.1.2(II) Of this document.