(胶片)SE2600配置指导-20110624.ppt

* Functions As the switching unit of the GGSN9811, the SFU exchanges service data for the system. The SFU has a control channel to detect the voltage, the current, and the temperature and provides protection against overvoltage, overcurrent, and overheat. The SFU also supports power-on and power-off of the power module manually or by running commands. Reliability The two SFUs and the two SFU modules integrated on the SRUs work in load-sharing mode. When an SFU is faulty or is replaced, the remaining three SFUs automatically carry out load balancing without interrupting services. * The SPU processes all the services of the GGSN9811. The SPU mainly processes data on the GTP control plane (GTP-C) and the GTP user plane (GTP-U). The SPU features rich routes and high security. The processing capability of the SPU determines the capacity of the GGSN. The SPUs can be inserted into slots from 1 to 8. It is recommended that you insert the SPU into slots from 3 to 8. The SPU supports the master/slave configuration and realizes the 1+1 hot backup mechanism. The GGSN9811 subrack can be inserted with a maximum of three pairs of SPUs. Optionally, an SPU can be inserted with a compress service processing card (CSPC) to perform complex functions, such as the content-based charging, IPv6 user plane, lawful interception, and IPSec encryption or decryption. * SE2600典型组网： A-SBC组网：称之为接入全代理组网。全代理主要用来接入从属这个核心网下的用户。对接入网屏蔽核心网的网络信息。 I-SBC组网：称之为互通网关组网。I-SBC部署在两个核心网之间，这两个核心网没有从属关系。在这种组网下也能够屏蔽对端核心网的信息。 * * 无论是A-SBC还是I-SBC，SE2600在两个网络之间通常都是通过对方网络的出口路由器连接，作为这两个网络的SBC业务的出接口。在这种双平面的组网中，对于SBC的业务接口，我们采用 不跨板的Trunk(负载分担) ＋ BFD探测的方式组网。 对于网管我们采用 跨板Trunk(主备)＋ARP探测 。 网管之所以用跨板trunk＋arp探测的原因是网管上对连接的要求没有业务那么高，并且使用跨板trunk在保证可靠信的情况下还可以节约IP地址。 业务接口之所以不采用跨板trunk是由于耗费的端口太多。因为如果一块LPU板坏掉，需要保证另外一块LPU板能够正常工作（这种情况下会使得trunk使用的接口翻番）。 * * 图中虽然使用了备份这个词，实际上LPU板上的业务的物理接口并非主备方式，一般使用的是负荷分担方式，说是主备是由于如果一块LPU板上的接口异常，另外一块LPU板会代替前一块LPU板。 * 根据话务量算出来的为单块LPU板的接口，实际使用中，为了网络安全都是双LPU双平面组网，所以接口是翻番的。光模块的数量是单接口的2倍。 接口板可以配置为光口或者电口，如