垂直连续电镀设备(VCP)取代龙门电镀线的必然趋势.pptx

GuangDe Dongwei Plating Equipment Technology Co., Ltd. 广德东威电镀设备技术有限公司 Jianbo Liu 刘建波;Advantage-自主研发，技术领先;Comparison Based on: Safety PK, Economy PK, Products Quality PK, etc. 对比基于：安全性对比，经济性对比，电镀产品质量对比等 ;Big fire risks exist in the hoist type plating equipments and many fire hazards are shown on the TVs 龙门线存在较大的火灾风险，而龙门线起火事故在电视中屡见报道 VCP equipments contains special fire-proof design and minimize human factors for fire hazards. Currently no any fire hazard happens。 VCP设备具有专门的防火设计，能够最大程度地减少火灾风险。迄今为止，东威公司生产的VCP设备没有发生过一起火灾；;VCP equipment VCP电镀线 Full sealed working environment and no bad smells 外觀整潔、全封閉式設計，工作環境良好，可实现四季恒溫控制;Equipment type 设备类型;;傳統龍門式電鍍線;;傳統龍門式電鍍線;VCP VS Hoist type VCP与龙门线对比 ;VCP ;Conclusion ： VCP running cost down around 25%； About 22 months, saving money can buy the equipment replace cost ;　;VCP for Ni_Au plating 镀镍金VCP;Up to present, KSDW has sold out more than 300pcs VCP lines and the cost saving is roughly more than 600 million RMB 迄今为止，东威公司已经制造销售了超过300条VCP电镀线。相比于龙门线，每年节约的生产成本大约超过6个亿人民币！ Also, KSDW has manufactured Ni_Au plating line. Because of the good uniformity, the Cp value of thickness is 1.67. Large quantity of gold is saved and customer benefits more. 东威公司生产的电镀Ni_Au线，由于电镀镀层均匀性控制得当，Cp值大于等于1.67，大大地节约了金盐的用量，为客户每月节约30-40万(镀金层厚度30uin)。 ;We are still considering 我们仍然在思考… Using VCP to finish Ni_Au plating job 采用VCP设备进行化镍金； Using VCP to finish PTH job 采用VCP设备进行化铜； Developing VCE to achieve copper cycling in PCB plant 开发垂直连续电解蚀刻VCE，解决PCB工厂的循环生产，最大程度节约铜资源； Vacuum sputtering 真空溅射设备取代PTH，达到PTH不再消耗水的目的； ;Sheet to Sheet FPC VCP – 片对片VCP;Roll to Roll VCP – 卷对卷VCP;Rigid Board VCP – 硬板VCP