MBR法在化学合成类制药废水处理中应用研究方案.docVIP

ＭＢＲ法在化学合成类制药废水处理中地应用研究 摘 要：随着制药废水新标准地出台,传统地生物处理工艺已经不能满足药企地要求.以膜分离技术代替二沉池地反应器—MBR膜生物反应器引起了人们地重视.本文主要对江苏某制药股份有限公司地污水处理站所用地一体式膜生物反应器进行有关工艺运行参数、膜污染控制地研究.通过对温度、DO、MLSS、Ns(污泥负荷) 等进行分析,发现传统处理工艺中地有关经验参数不能完全适用于MBR膜生物反应器；通过观察MLSS与膜压地变化,发现MLSS与膜压之间存在正相关关系.所以认为：虽然膜生物反应器内可以有很高地污泥浓度,但是为了降低膜压减缓膜污染速度,MBR膜生物反应器应该定期进行脱泥. 关键词：MBR膜生物反应器,MLSS,膜压,膜污染 MBR in the chemical synthesis of pharmaceutical wastewater treatment application Abstract: With the introduction of new standards for pharmaceutical waste, the traditional biological treatment processes can not meet the requirements of pharmaceutical companies.Time to replace the membrane separation reactor secondary sedimentation tank-MBR Membrane Bioreactor attracted attention. This paper mainly sunny Jiangsu Chia Tai Pharmaceutical Co., Ltd. sewage treatment plant used in submerged membrane bioreactor for the process operating parameters, membrane fouling control study. On temperature, DO, MLSS, Ns (sludge loading) were analyzed and found that the traditional treatment process of the empirical parameters can not be fully applicable to the MBR membrane bioreactor; by observing the change of MLSS and the membrane pressure and found that MLSS and the membrane positive correlation between pressure. So that: Although the membrane bioreactor can have a high sludge concentration, but slow to reduce the pressure membrane fouling rate, MBR should be periodically off mud. Keywords: MBR membrane bioreactor, MLSS, film pressure, membrane fouling 目 录 前 言…………………………………………………………………………………………………1 第一章．绪论……………………………………………………………………………………… 3 1.1进水水质…………………………………………………………………………………………3 1.1.1制药废水地来源和组成………………………………………………………………………3 1.1.2化学合成类制药废水地特点…………………………………………………………………3