模具设计与制造专业英语黄义俊统一模板模具Unit2章节.pptVIP

Unit 2 Die Design Unit 2 Die Design 2.1 Lesson 3 Deformation Modes in Sheet Forming The wide variety of sheet metal parts for both the automobile and electronic industries is produced by numerous forming processes that fall into the generic category of “sheet-metal forming”. Sheet-metal forming（also called stamping or pressing）is often carried out in large facilities hundreds of yards long． It is hard to imagine the scope and cost of these facilities without visiting an automobile factory , standing next to the gigantic machines, feeling the floor vibrate, and watchin