转炉煤气尘泥的利用研究.pdfVIP

转炉煤气尘泥的利用研究 ·1 · 转炉煤气尘泥的利用研究 高燕军 （西安西矿环保科技有限公司，陕西西安 710055 ） 摘 要 传统的转炉烟气除尘系统采用湿法除尘，其产生的粉尘为沉淀的污泥，俗称“红泥”，其中含有的氧化钙 已经充分水化，压制成球后不容易破裂，而采用目前的干法电除尘工艺，捕集到的粉尘含有较多石灰粉、氧化铁、 少量碳，粒度较细，80%以上的粒度为5～76.4μm ，属高细粉状态物质。它的运输方式大部分以机械运输为主，目 前国内已有气力输送的实例，但小问题比较多。转炉尘泥的直接利用一直困扰着许多厂家。将转炉尘泥用于转炉炼 钢、烧结、制备铁红颜料？究竟怎样的利用方法才是最经济、可靠地利用方法。每个钢厂根据自身情况采用合理的 利用方式将大大降低转炉炼钢除尘的成本。 关键词 转炉粉尘，红泥，气力输送 The Research and Utilization of Converter Dust Gao Yanjun (Xi’an Xikuang Environmental Protection Co., Ltd., Xi’an 710055, China) Abstract Traditional converter flue gas cleaning system using wet process, the dust is precipitated sludge, commonly known as “red mud”, which contains calcium oxide has been fully hydrated and pressed into the ball is not easy to rupture, while the use of the present dry process, trapping the ash containing more lime powder, iron oxide, a small amount of carbon and the grain size is fine, more than 80% of the size is 5 ~ 76.4μm, belongs to the high fine powder material. Its transport mode is mainly based on mechanical transport, and the current domestic pneumatic conveying has been the case, but the problem is more.The direct use of converter dust has been plagued by many manufacturers. The converter is used for converter steelmaking, sintering, the preparation of iron red material? How to use the method is the most economical and reliable method. Each steel mill according to their own situation to adopt a reasonable way to use will greatly reduce the cost of converter steelmaking. Key words the converter dust,