毕业设计（论文）-10KV变电站的电气一次设计 (2).docVIP

西南科技大学城市学院本科生毕业论文 PAGE \* MERGEFORMAT IV 10KV变电站的电气一次设计 摘要:本设计设计了一个电子厂的供电系统，在满足工厂供电设计中安全、可靠、优质、经济的基本要求的前提下，本文首先根据全厂和车间的用电设备情况和生产工艺要求，进行了负荷计算，通过功率因数的计算，进行无功补偿设计（包括无功补偿容量计算和补偿设备选择、校验），确定了电子厂的供电方案，通过技术经济比较，确定了供电系统的主接线形式，选择了主变压器的台数和容量。其次，本文设计了厂区供电和配电网络，进行了车间变电所以及车间配电系统和车间电气设计，按照经济电流密度法，选择了合适的导线和电缆，通过合理设置短路点，进行正确的短路电流计算，进行了主要电气设备的选型和校验。 关键词：供电系统； 负荷计算； 主变压器； 设备选择  Abstract :The design of an electronic factory power supply system, power plant design to meet safety, reliability, quality, basic requirements of the economy under the premise of this paper, according to all electrical equipment factory and workshop conditions and production process requirements, for a load calculation, by calculating the power factor, reactive compensation in the design (including reactive power compensation capacity calculation and compensation equipment selection, calibration), to determine the supply of electronic works program, through technical and economic comparison of the power supply system to determine The main connection form, select a main transformer station number and capacity. Secondly, the paper design of the power plant and distribution network, conducted a workshop and the workshop substation electrical distribution systems and plant design, in accordance with the economic current density method, select the appropriate wire and cable, through a reasonable set short-circuit point, for correct short-circuit current calculation, carried out a major electrical equipment selection and validation. . Key words: power system， load calculation， transformer ，equipment selection 目 录 TOC \o 1-3 \h \z \u HYPERLINK \l _Toc290148434 第0章、绪 论 PAGEREF _Toc290148434 \h 1 HYPERLINK \l _Toc290148435 第1章、分析原始资料，确定电源的引入方式 PAGEREF _Toc290148435 \h 3 HYPERLINK \l _Toc290148436 1.1.工厂总平面图 PAGEREF _Toc290148436 \h 3 HYPERLINK \l _Toc290148437 1.2.工厂生产任务规模及产品规格 PAGEREF _Toc290148437 \h 3 HYPERLINK \l _Toc290148438 1.3工厂负荷情况 PAGEREF _Toc290148438