- 1、本文档共6页,可阅读全部内容。
- 2、原创力文档(book118)网站文档一经付费(服务费),不意味着购买了该文档的版权,仅供个人/单位学习、研究之用,不得用于商业用途,未经授权,严禁复制、发行、汇编、翻译或者网络传播等,侵权必究。
- 3、本站所有内容均由合作方或网友上传,本站不对文档的完整性、权威性及其观点立场正确性做任何保证或承诺!文档内容仅供研究参考,付费前请自行鉴别。如您付费,意味着您自己接受本站规则且自行承担风险,本站不退款、不进行额外附加服务;查看《如何避免下载的几个坑》。如果您已付费下载过本站文档,您可以点击 这里二次下载。
- 4、如文档侵犯商业秘密、侵犯著作权、侵犯人身权等,请点击“版权申诉”(推荐),也可以打举报电话:400-050-0827(电话支持时间:9:00-18:30)。
查看更多
【精选】6.1.1 TT6.1.1 TT
Title: Test Tolerances for E-UTRAN FDD Intra-frequency RRC Re-establishment
Source: Spirent Communications
1. Introduction
The purpose of this document is to present the methodology and principles used for the development of Test Tolerances for RRM test 6.1.1: E-UTRAN FDD Intra-frequency RRC Re-establishment. This test is part of GCF Priority 1.
The test case in question, from TS 36.521-3, is:
6.1.1, E-UTRAN FDD Intra-frequency RRC Re-establishment
This document describes the process to derive the Test Tolerances. The calculations are provided in the accompanying spreadsheet.
2. Test case in TS 36.521-3
The test conditions are defined in the following extract from TS 36.521-3 v9.1.0. The test requirements are the only section provided.
6.1.1 E-UTRAN FDD Intra-frequency RRC Re-establishment
Some clauses skipped
6.1.1.5 Test requirement
Table 6.1.1.5-1 defines the primary level settings including test tolerances for E-UTRAN FDD Intra-frequency RRC Re-establishment test case.
Table 6.1.1.5-1: Cell specific test parameters for E-UTRAN FDD intra-frequency RRC Re-establishment test case
Parameter Unit Cell 1 Cell 2 T1 T2 T3 T1 T2 T3 E-UTRA RF Channel Number 1 1 BWchannel MHz 10 10 OCNG Patterns defined in A.3.2.1.1 (OP.1 FDD) and in A.3.2.1.2 (OP.2 FDD) OP.1 FDD OP.1 FDD OP.2 FDD OP.2 FDD OP.2 FDD OP.1 FDD PBCH_RA dB
0
0 PBCH_RB dB PSS_RA dB SSS_RA dB PCFICH_RB dB PHICH_RA dB PHICH_RB dB PDCCH_RA dB PDCCH_RB dB PDSCH_RA dB PDSCH_RB dB OCNG_RANote 1 dB OCNG_RBNote 1 dB dB 1.54 + TT -Infinity -Infinity -3.79 + TT 4 + TT 4 + TT Note 2 dBm/15 KHz -98 dB 7 + TT -Infinity -Infinity 4 + TT 4 + TT 4 + TT RSRP Note 3 dBm/15 KHz -91 +TT -Infinity -Infinity -94 + TT -94 + TT -94 + TT Propagation Condition AWGN Note 1: OCNG shall be used such that both cells are fully allocated and a constant total transmitted power spectral density is achieved for all OFDM symbols.
Note 2: Interference from other cells and noise sourc
您可能关注的文档
- 【精选】6 多媒体技术应用专题6 多媒体技术应用专题.ppt
- 【精选】6-1_附加:钢筋下料计算例题6-1_附加:钢筋下料计算例题.ppt
- 【精选】6 项目质量管理6 项目质量管理.ppt
- 【精选】6 第三章 教育口语6 第三章 教育口语.ppt
- 【精选】6(新余四中 曾聪根)热学6(新余四中 曾聪根)热学.ppt
- 【精选】6-4多级放大电路6-4多级放大电路.pdf
- 【精选】5考试及大运动量时的营养5考试及大运动量时的营养.ppt
- 【精选】6-3微积分的基本公式6-3微积分的基本公式.ppt
- 【精选】6 光接口类型和参数6 光接口类型和参数.pdf
- 【精选】6-4安培环路定 理6-4安培环路定 理.ppt
文档评论(0)