高层剪力墙结构混凝土整体浇筑技术研究和应用.pdfVIP

年第 期 混凝土与水泥制品 2011 10 2011 No10 10 月 CHINA CONCRETE AND CEMENT PRODUCTS October 高层剪力墙结构混凝土整体浇筑技术的研究与应用 1 暴雨婷2 吕 春 ， （ 齐齐哈尔大学建筑与土木工程学院， ； 青岛理工大学管理学院， ） 1. 161006 2. 266033 摘 要：现行高层剪力墙结构墙体和楼板混凝土施工中，首先进行墙体混凝土的浇筑，然后进行楼板混凝土的 浇筑。 这种通行的做法使墙体混凝土与其顶部楼板混凝土之间存在贯通的施工缝，容易出现施工质量问题，同时施 工人员停工等待时间过长、 无法充分进行流水施工。 在齐齐哈尔大学国际交流中心工程剪力墙及楼板混凝土施工 中，采用了一种先支设上部楼板模板、后支设下部墙体模板，进而同时浇筑剪力墙和楼板混凝土的施工技术。 通过 与传统混凝土浇筑方法在施工质量、人员设备及材料投入情况、工期等方面的比较，证明了采用该技术能够明显地 提高工程质量、降低人工费用、缩短施工工期。 关键词：剪力墙结构；施工缝；整体浇筑；混凝土 Abstract: In general, in the concrete construction in the wall and upper floor of high-rise shearing wall structure, the method that pouring concrete for the upper floor after concreting for the wall is used. This common practice produces the construction seams in the concrete between top of wall and upper floor, which is prone to construction quality problems, while the non-work waiting time of workers is too long, which causes them unable to fully carry out the flow construction. In the construction of concrete shearing wall and floor of Qiqihar International Education Center, a new construction technology is used, which is installing floor formwork first and then installing wall formwork, after that pouring concrete of shearing wall and floor at the same time. Compared with the traditional method in construction quality, workers, equipment, material investment, construction period, etc., the new construction technology is proved to be able to shorten construction period, reduce expenses for labor