1950RT低温冰机技术规范.docx

CENTRIFUGAL WATER CHILLERSPART 1 – GENERALWORK INCLUDEDThis Section specifies the requirements necessary to furnish and install the water-cooled centrifugal liquid chillers, including start-upand commissioning, complete, with all necessary control and starting equipment.The water-cooled liquid chillers are intended for use in conventional chilled water air conditioning heating system.Electrical component design and selection shall be based upon 6,600volt electricalpower supply.Equipment includesChiller package.Charge of refrigerant and oil. Connections of chilled water piping andcondensate water pipingControls.Starters.Electrical power connections from starter to control panel.Vibration IsolationEquipment installation, start-up, commissioning and maintenance.ReferencesANSI/ASHRAE 15-Safety Code for MechanicalRefrigeration.ANSI/ASHRAE 90-Energy Conservation in NewBuilding Design.ANSI/ASME SEC 8-Boiler and Pressure Vessel Code.ANSI/ASME B31.5 -Refrigeration Piping.ANSI/UL 465-Central Cooling Air Conditioners.ARI 550-Centrifugal or Rotary Water Chilling Packages.QUALITY ASSURANCEThe entire unit, with all components, shall be UL labeled and bear the respective labeland comply with P.R. China standards.Factory test chiller performance and certify in accordance with ARI 550-92. All factory tests shall be witnessed by the Owner or designated representatives as required. Minimum run-in test shall be 4 hours continuous on the test pad and maintain LWT at plus or minus 0.28 degree C (0.5 degree F) tolerance. Submit separate price breakdown for factory performance test of only one machine, or for testing all machines in initial purchase.The Owner shall be notified at least one month in advance of the test and shall be allowed to witness all run-in tests on the equipment destined for this project.The construction of chiller components and assemblies which come in contact withchilled water and condenser water shall be compatible with the water treatmentpackage used to inhibit c