单一控制台，简化IT基础设施管理.ppt

* * * * * * * * * * * * (lvl1 information is sufficient) DSView manual excerpt –lvl1 info may be duplicate = Adding User Accounts The following information is configured when a user account is created: ? Whether the user will be authenticated using the DSView 3 software internal authentication or an external authentication server. See Authentication Services.? The user groups in which the user will be included. Each user group contains specific access rights that allow a user to perform specific actions. See User Groups.? The preemption level for interrupting or disconnecting serial or KVM sessions. See Preemption Levels.You must have DSView 3 software administrator or user administrator rights to add a user. To add a user account: 1. Click the Users tab.2. Click Add. The Add User Account Wizard will appear. Click Next.3. The Select Authentication Service window will open. This window lists the DSView 3 software internal service and all the external authentication services that have been added, which may be used to authenticate users when they log in. See Authentication Services.Select an authentication service and then click Next. ? If you selected DSView Internal, go to step 4.? If you selected any other authentication service, go to step 5.4. The Type in User Credentials window will open. a. Type a username, password and confirm the password of the user you are adding.Usernames may contain up to 256 non-case sensitive characters (if a RADIUS external authentication service will be used, the limit is 253 characters). Usernames are case-preserving. For example, if an account named JDoe is created, it will be saved as JDoe in the DSView 3 server, but a user may log in as JDoe, jdoe, JDOe and so on. Passwords may contain 3-64 characters. Passwords will never expire unless User must change password at next login is selected in the Unit Password window, or Passwords Expire information is specified in the Authentication Service User Account Policies window. A DSVie