单片机仿真之ADC8032数模转换与显示.doc

程序： #include reg52.h #include intrins.h #define uint unsigned int #define uchar unsigned char #define delay4us() {_nop_();_nop_();_nop_();_nop_();} sbit RS = P2^0; sbit RW = P2^1; sbit E = P2^2; sbit CS = P1^0; sbit CLK = P1^1; sbit DIO = P1^2; uchar Display_Buffer[] = 0.00V; uchar code Line1[] = Current Voltage:; void DelayMS(uint ms) { uchar i; while(ms--) { for(i=0;i120;i++); } } bit LCD_Busy_Check() { bit result; RS = 0; RW = 1; E = 1; delay4us(); result = (bit)(P00x80); E = 0; return result; } void LCD_Write_Command(uchar cmd) { while(LCD_Busy_Check()); RS = 0; RW = 0; E = 0; _nop_(); _nop_(); P0 = cmd; delay4us(); E = 1; delay4us(); E = 0; } void Set_Disp_Pos(uchar pos) { LCD_Write_Command(pos | 0x80); } void LCD_Write_Data(uchar dat) { while(LCD_Busy_Check()); RS = 1; RW = 0; E = 0; P0 = dat; delay4us(); E = 1; delay4us(); E = 0; } void LCD_Initialise() { LCD_Write_Command(0x38); DelayMS(1); LCD_Write_Command(0x0c); DelayMS(1); LCD_Write_Command(0x06); DelayMS(1); LCD_Write_Command(0x01); DelayMS(1); } uchar Get_AD_Result() { uchar i,dat1=0,dat2=0; CS = 0; CLK = 0; DIO = 1; _nop_(); _nop_(); CLK = 1; _nop_(); _nop_(); CLK = 0;DIO = 1; _nop_(); _nop_(); CLK = 1; _nop_(); _nop_(); CLK = 0;DIO = 1; _nop_(); _nop_(); CLK = 1;DIO = 1; _nop_(); _nop_(); CLK = 0;DIO = 1; _nop_(); _nop_(); for(i=0;i8;i++) { CLK = 1; _nop_(); _nop_(); CLK = 0; _nop_(); _nop_(); dat1 = dat1 1 | DIO; } for(i=0;i8;i++) { dat2 = dat2 ((uchar)(DIO)i); CLK = 1; _nop_(); _nop_(); CLK = 0; _nop_(); _nop_(); } CS = 1; return (dat1 == dat2) ? dat1:0; } void main() { uchar i; uint d; LCD_Initialise(); DelayMS(10); while(1) { d = Get_AD_Result()*500.0/255; Display_Buffer[0]=d/100+0; Display_Buffer[2]=d/10%10+0; Display_Buffer[3]=d%10+0; Set_Disp_Pos(0x01); i = 0; while(Line1[i]!=\0) { LCD_Write_Data(Line1[i+1]); } Set_Disp_Pos(0x46); i = 0; while(Display_Buffer[i]!=\0) {