发动机和ECTECU正常汽车专业英语.PPT

汽 车 专 业 英 语Special English for Automobile *1 Check if the key which did not start the engine has been registered and if it is possible to start with other already registered key. *1 检查不能起动发动机的钥匙是否已进行注册以及发动机能否用其它已注册的钥匙起动。 6.CIRCUIT INSPECTION CIRCUIT DESCRIPTION WIRING DIAGRAM WIRING DIAGRAM When a key that outputs B2795 is found, register this key. When B2795 is not output, there is a possibility that the unregistered key has been inserted before. (Engine and ECT ECU is normal.) Inquire a customer the condition of using the system to find the cause of the trouble. (Example: Another key has been inserted, etc.) 询问客户使用该系统的情况以找出故障原因。 （例如：插入过其它钥匙等等。） CHECK： Using an oscilloscope or TOYATA hand-tester, check that noise is included in the signals sent to the CODE terminal of ENGINE and ECT ECU. 检查： 使用示波器或丰田手持测试仪检查到发动机和ECT ECU上CODE端子中的信号里是否含有杂波。 汽车专业英语 Special English for Automobile Section B Service and Repair Manual 汽 车 维 修 手 册 5.PROBLEM SYMPTOMS TABLE 故障症状表 IN-35 IN-35 Engine and ECT ECU 发动机和ECT ECU Immobiliser is not set. (Engine starts with key codes other than the registered key code.) 停机系统不能设定（发动机以未注册的钥匙代码起动） See page 参见页数 Suspect Area 可能范围 Symptom 症状 *1 IN-35 BE-174 - IN-35 1.Key 2.Wire harness 3.Transponder key coil 4.Amplifier 5 Engine and ECT ECU Engine does not start See page Suspect Area Symptom *1 IN-35 BE-174 - IN-35 1.钥匙 2.线束 3.无线收发钥匙线圈 4.放大器 5.发动机和ECT ECU 发动机 不能 起动 参见页数 可能范围 症状 IN-35 BE-174 - IN-35 1.Wire harness 2.Transponder key coil 3.Amplifier 4. Engine and ECT ECU Security indicator is always On. (Although code has been registered in the automatic registration mode, indicator is not OFF) See page Suspect Area Symptom IN-35 BE-174 - IN-35 1. 线束 2.无线收发钥匙线圈 3.放大器 4.发动机和ECT ECU 发安全指示灯一直亮（虽然代码已用自动注册模式注册，但指示灯不熄灭） 参见页数 可能范围 症状 IN-35 BE-174 - IN-35 1.Wire harne