24G重选与快速返回功能开启参数设置说明20140820.docxVIP

24G重选与快速返回功能开启参数设置说明温州分公 录1.2G到4G重选参数设置11.1BSC级参数11.2小区级参数11.3邻区级参数22.2G到4G快速返回参数设置42.1BSC级参数42.2小区级参数42G到4G重选参数设置BSC功能LTE system information就是2G网络到4G网络的重选功能。BSC级参数24G重选功能的功能号FEA=1965，开启该功能需将该功能状态设为ON。修改指令：ZW7M:FEA=1965:ON;小区级参数24G重选功能的小区级参数如下：（ZEQO:SEG=:MIS;）LTE CELL RESELECTION PARAMETERS: GSM PRIORITY.........................(GPRIO). 2 WCDMA PRIORITY.......................(WPRIO). 3 PRIORITY SEARCH THRESHOLD............(PSTHR). ALWAYS LOW PRIORITY THRESHOLD...............(LPTHR). ALWAYS RESELECTION ALGORITHM HYSTERESIS.....(HPRIO). RULE DISABLED TIME HYSTERESIS......................(TIMEH). 5 s UTRAN ADJ CELL THRESHOLD ............(UTTR).. 24 dBUTRAN QUAL RX MIN ...................(UQRL).. -115 dBm参数参数名现网设置值描述范围GPRIOGSM priority2With this parameter, you can define an absolute priority of the serving GSM cell. Value 0 is the lowest and value 7 is the highest priority. The value cannot be the same as WCDMA priority.0-7PSTHRPriority search thresholdAWith this parameter, you can define the threshold for the serving cell that controls the measurement of the lower priority inter-RAT cells or frequencies.低于该门限启动到低优先级的测量，是一个绝对值。‘-98...-56?dBm, step 3?dBLPTHRLow priority thresholdAWith this parameter, you can define a threshold for the serving cell below which the MS is allowed to reselect to lower priority cells.是到低优先级的判决门限，是基于rxlevmin的相对值0...28?dB, step 2?dBHPRIOPriority based reselection hysteresis0（RULE DISABLED）With this parameter, you can define a hysteresis in the priority reselection algorithm.Rule disabled (0), 5 dB (1), 4dB (2), 3 dB (3)TIMEHTime hysteresis0（5s）With this parameter, you can define a time hysteresis in priority based cell reselection algorithm in the serving cell.5 sec (0), 10 sec (1), 15 sec (2), 20 sec (3)WPRIOWCDMA priority3With this parameter, you can define an absolute priority of the WCDMA neigbor cells.The value of this parameter cannot be the same as GSM priority.0-7UTTRUtran Threshold Reselection24Wit