linux led驱动程序分析.docVIP

linux?led?驱动程序分析 (2010-08-16 23:20:12) 转载 标签： linux led 驱动程序分析 it 分类： linux程序我的分析 分析版本V0.1 我先说一下驱动的加载顺序如果我们在加载模块，使用insmod，程序就执行module_init(TX2440_led_init); 注册如果我们要卸载模块，使用rmmod ，程序就执行module_exit(TX2440_led_exit); 卸载在执行的时候不会在用到上面两个函数 #include linux/module.h //模块加载的头文件#include linux/kernel.h#include linux/fs.h???? //文件系统????#include linux/init.h?? //用户定义模块初始函数名需引用的头文件#include linux/delay.h#include asm/irq.h//#include asm/arch/regs-gpio.h#include mach/regs-gpio.h?//#include asm/hardware.h#include mach/hardware.h#include linux/device.h#include linux/gpio.h #define DEVICE_NAME?TX2440-led????//设备名称static int LED_Major = 0;???// 主设备号? 如果是0系统自己分配 #define LED_OFF????????? 0????????? //几个宏定义#define LED_ON????????? 1#define ALL_LED_OFF????? 3#define ALL_LED_ON?????? 4 // 用来指定LED所用的GPIO引脚static unsigned long led_table [] ={?S3C2410_GPF(0),??????????S3C2410_GPF(1),?S3C2410_GPF(2),?S3C2410_GPF(3),};???????????????????????? //定义引脚的寄存器数组（无符号长整形，对应于引脚的地址） static int TX2440_led_open(struct inode *inode, struct file *file){//?MOD_INC_USE_COUNT;?printk(TX2440-LED Driver Open Called!\n);?return 0;}???????????????????????? static int TX2440_led_release(struct inode *inode, struct file *file){//?MOD_DEC_USE_COUNT;?printk(TX2440-LED Driver Release Called!\n);?return 0;} static int TX2440_led_ioctl( struct inode *inode, struct file *file, unsigned int cmd, unsigned long arg){?int i;?if (arg 4)?{??return -EINVAL;?}?switch(cmd)?{??case LED_ON:? //set the pin????第几盏灯亮???s3c2410_gpio_setpin(led_table[arg], 0);???break; ??case LED_OFF:? //clr the pin?? 第几盏灯灭???s3c2410_gpio_setpin(led_table[arg], 1);???break;?????case ALL_LED_ON:? //set all pin 全亮???for (i = 0; i 4; i++)????s3c2410_gpio_setpin(led_table[i], 0);???break;?????case ALL_LED_OFF:? //clr all pin 全灭???for (i = 0; i 4; i++)????s3c2410_gpio_setpin(led_table[i], 1);???break; ??default:???return -EINVAL;?}} static struct file_operations TX2440_led_fops ={?.owner? =?? THI