Shigley’s Mechanical Engineering Design, 9th Edition.doc

Shigley’s Mechanical Engineering Design, 9th Edition First Printing Corrections The authors apologize for any inconvenience caused by errors in the first printing of the ninth edition of Shigley’s Mechanical Engineering Design. We had made every attempt to avoid these problems. However, with a text of over 1000 pages and a solutions manual of over 760 pages there were bound to be errors, typographical and otherwise. In this edition, there were over 600 new and revised problems. Many of the errors in Appendix B, Answers to Selected Problems, were due to improper rounding and thus are only off by a small percentage. However small these errors need to be corrected and reported. Richard G. Budynas J. Keith Nisbett  Shigley’s Mechanical Engineering Design, 9th Edition Errata First Printing Corrections Page 19. Equation (1-5) should be changed ro read “”. Page 20. Figure 1-4. Change “lengths a, b, and c ” to “lengths b, c, and d ”. Page 27. Second line of Prob. 1-12. Change “16”to “32”. Page 47. Last line. Change “recrystallation” to “recrystallization”. Page 67. Prob. 2-3. First line. Change “strength-to-weight density” to “strength-to-density”. Page 116. Third line before Eq. (3-58). Change first comma to a period. Page 144. In Prob. 3-122 statement and figure. Change R to Ri (3 places total). In Prob. 3-124. Change R to Ri. In Prob. 3-125. Change R to Ri. Page 146. In Prob. 3-142. In third column, change “mm” to “in”. Page 173. In second integral of Eq. (6) change “dx ” to “d( ”. Page 202. In Prob. 4-71. Change “(4-15)” to “(4-18)”. Page 203. In Prob. 4-78. In figure, Section A-A. Change “1.375 in” to “0.375 in” (2 places). Page 241. In third line. Change “Eq. (5-34)” to “Eq. (5-33)”. Page 260. In Prob 5-57. Change “Design” to “Using F = 416 lbf, design”. In Prob. 5-59. Fifth line. Change “1.5 in” to “0.5 in”. Page 263. Prob. 5-87. First line. Change “5-44” to “5-86”. Prob. 5-88. Second line. Change (40,2)” to “(20,1)”. Page 333. In Table 6-11