nema0183提取有效字符程序.docVIP

nema0183提取有效字符程序 ＃include stdio.h ＃include dos.h ＃include time.h #define LSB 0 #define MSB 1 #define RXR 0 #define TXR 0 #define IER 1 #define IIR 2 #define LCR 3 #define MCR 4 #define LSR 5 #define MSR 6 #define Com1_base 0x3f8 #define uchar unsigned char volatile uchar inputData; volatile uchar onInput = 0x00; volatile uchar onOutput = 0x00; volatile uchar inputdata[256]; /*设设置接收缓冲区大小*/ volatile unsigned int count; /*中断接收的数据数目*/ int datacount;/*当前已发送数据条数*/ void interrupt (*OldVect)(); /*函数是用来获取中断处理程序的入口地址的*/ void interrupt SerialISR(); void InitCom() { uchar inttemp; /*设置波特率什么的*/ outportb(Com1_base+LCR,0x80); /*使LCR的高位为1，以便读取其它寄存器*/ outportb(Com1_base+LSB,0x0c); /*除数锁存器（低8位）DLL*/ outportb(Com1_base+MSB,0x00); /*除数锁存器（高8位）DLH 产生2400波特率*/ outportb(Com1_base+LCR,0x03); /*8位数据，1位停止位，无校验*/ outportb(Com1_base+IER,0x01); /*接收采用中断方式*/ /*设置中断向量*/ OldVect = getvect(0x0c); /*函数是用来获取中断处理程序的入口地址的*/ disable(); inttemp = inportb(0x21)0xef; outportb(0x21,inttemp); setvect(0x0c,SerialISR); /*设置SerialISR的中断入口地址为0X0C*/ enable(); } void CloseCom() { disable(); outportb(Com1_base+IER,0x00); *禁止中断*/ outportb(Com1_base,0x00); outportb(0x21,inportb(0x21)|~(0xef)); setvect(0x0c,OldVect); } void interrupt SerialISR() { /*串口中断服务代码*/ inputData = inportb(Com1_base+RXR); onInput = 0x01; inputdata[count]=inputData; count++; /*服务代码结束*/ outportb(0x20,0x20); /*中断结束的代码*/ } void SendChar(uchar key) { while( ((inportb(Com1_base + LSR)) 0x40) == 0); outportb(Com1_base + TXR,key); } /*...........延时函数......................*/ void delay(unsigned int n) { unsigned int i,k; for(k=0;kn;k++) { for(i=1;i1142;i++) ; } } /*........CDMA命令发送函数.................*/ void CDMA_CommandSend(char *p,unsigned int n) { int i,k,m,l