1998-2005奥迪2.8L V6发动机缸盖拆装程序.pdf

Cylinder head, removing and installing Page 1 of 7 Audi C5 Platform 1998 - 2005 2.8 Liter V6 5V Engine Mechanical, Engine Code(s): AHA, ATQ 15 - Engine - Cylinder head, Valvetrain Cylinder head, removing and installing Following instructions apply to left cylinder head. Removing Remove ribbed belt = 6. Remove toothed belt = 10. Remove noise insulation panel (arrows). Unbolt left and right-side front exhaust pipes from exhaust manifolds. Unbolt exhaust system from transmission bracket. Place clean VW1306 receptacle or drain pan under engine. Remove filler cap from coolant expansion tank. WARNING! The cooling system is pressurized when the engine is warm. When opening the expansion tank, wear gloves and other appropriate protection, cover the cap with a cloth and open carefully to relieve system pressure slowly. x-ebahn:///C:/Program%20Files/eBahn/data/AUDI-C-C5-GE01.ebn/AUDI/C/C5/Repair%... 8/25/2008 Cylinder head, removing and installing Page 2 of 7 Unscrew drain plug (arrow) on left-side of radiator. Install drain hose to connection if necessary. Remove coolant drain plug on engine (arrow) using 3247 hex ball socket, and drain coolant. Remove intake air duct between mass air flow sensor and intake air elbow. Disconnect harness connectors for intake manifold tuning valve -3- and intake air temperature sensor -4-. Move wiring clear. x-ebahn:///C:/Program%20Files/eBahn/data/AUDI-C-C5-GE01.ebn/AUDI/C/C5/Repair%... 8/25/2008 Cylinder head, removing and installing Page 3 of 7 Disconnect vacuum lines (arrows). Disconnect hose between Evaporative Emission (EVAP) canister purge regulator valve