伯力鸠斯立磨3hydraulic-function-modified1.ppt

* * Page: * Reservoir Pump Pump Components description Y1, Y3, Y5, Y7 are called pressure valves Y2, Y4, Y6, Y8 are called pressure relief valves Electrically actuated Components description Y1, Y3, Y5, Y7 are called pressure valves De-energized, normal open energized, valves closed Components description De-energized, normal closed energized, valves open Y2, Y4, Y6, Y8 are called pressure relief valves Components description No-load start up operation By starting command from the control panel... All valves are de-energized and the pumps start running The pumps deliver oil pressureless into the reservoir, via the filters and the pressure valves Y1, Y3, Y5, and Y7 When the mill has been at a standstill for 2 to 4 hours, but just once per 24 hours, the pistons of the hydraulic cylinders are drawn into their end positions (alternately always 2 x), in order to ensure an exchange of oil in the area of the seals. In all other cases, the starting procedure begins with pressurization to the start-up pressure. No-load start up operation By activating the pressure valve Y1 and the pressure relief valve Y6 and switching on the pump 1 The oil stream flows through the filter ...through the non return-valve Pressure valve Y1 is closed in energized condition Pressure valve leaded by TüV Pressure relief valve Y2 is closed in de-energized condition The oil stream flows to the piston rod side of the cylinder, the piston moves downwards The piston of the other cylinder, corresponding to the same roller pair, moves upwards no-return valve Pressure relief valve Y6 is open, in energized condition Minimal pressure limiting valve, manual adjustable The oil from the hydraulic cilinder flows back into the reservoir No-load start up operation Exchange of oil in the cylinders of the bucket elevator side When the upper end position of the piston in the hydraulic cylinder I, or the lower end position in the cylinder II,... indicated by the ultrasonic measuring devices, has been reache