IPMI Command 格式介绍.ppt

IPMI Command format Introduction Agenda BMC_CFG.exe Command Specification information Completion codes NetFN ( Network Function ) code KCS interface-BMC Request message format IPMITool send command and response data DiagPro BMC Module Command format SMIC BMC Request Message format BT interface-BMC Request Message format IPMI LAN message Format Serial/Modem Basic mode message Fields Serial/Modem Terminal mode to BMC Command Number Assignments and Privilege Levels BMC_CFG.exe 例子 BMC_CFG.exe manual command configuration How to get a sensor value BMC_CFG.exe send command from file BMC_CFG.exe response data file # # File Name h21j5532.rpt # Report of Committing GETGAT.DAT # Action DateTime: Mon Aug 21 09:55:32 2006 # # BMC Config Utility V1.12.0.15, (C)2004 OSA Technologies, Inc. # [Command 1 ]: Request: netFn = c, cmd = 2, RqSA = 20, LUN = 0, data length = 4 data = 1 c 0 0 Respond: cmd = 2, cCode = 0, data length = 5 data = 11 0 0 0 0 Message: Commit successful Command Specification information NetFn code（6bit）: 网络功能码(参考IPMI2.0 SPEC 66页) LUN-Logic Unit Numner(2bit): 相同的物理地址下的子地址号 Completion code(完成码): 发送命令后返回的完成码，0值表示成功，非0值表示错误，错误代码(参考IPMI2.0 SPEC 66页) Request Data: 发送命令所需的数据 (参考IPMI2.0 SPEC 相对应的命令下的说明) Response Data 发送命令后, BMC返回的数据 (参考IPMI2.0 SPEC 相对应的命令下的说明) Completion codes. (Page 66) NetFN ( Network Function ) code. (Page 64) KCS interface-BMC Request message format IPMITool send command and response data 例子 DiagPro BMC Module Command format 例子 SMIC BMC Message format BT interface-BMC Message format IPMI LAN message Format Serial/Modem Basic mode message Fields Serial/Modem Terminal mode to BMC Command Number Assignment and Privilege Level(562 Page) Global/BMC WD/BMC Device Command Number(562 Page) * * 手工填入命令和数据 返回的数据和数据长度 (不显示完成码) #The data format is as the following: # NetFn CmdNum RqSA RqLUN RqLen RqData # 0C 02 20 00 04 01 0c 00 00 Test file: 发送的命令和数据 返回的命令和数据 返回的文件名随机生成 发送命令后返回的完成码， 0值表示成功，非0值表示错误， 错误代码参考I