stm32操作nrf24l01.docVIP

stm32操作nrf24l01 #include stm32f10x_lib.h #include NRF24L01.h #include string.h void delay_ms(u16 time); void delay_us(u32 Nus); u8 TxBuf[32]={0}; /**********************************************************************/ #define uchar unsigned char extern u8 it_msg,led_flash; extern u8 TX_ADDRESS[TX_ADR_WIDTH]={0x34,0x43,0x10,0x10,0x01}; //发送地址 extern u8 RX_ADDRESS[RX_ADR_WIDTH]={0x34,0x43,0x10,0x10,0x01}; //发送地址 extern u8 rx_buf[TX_PLOAD_WIDTH]; extern u8 tx_buf[TX_PLOAD_WIDTH]; extern u8 status_buf[TX_PLOAD_WIDTH]; extern u8 flag,nrf_baud,_it0,_it1,_it2,_it3,nrf_Pipe,nrf_Pipe_r; /**********************************************************************/ uchar SPI_RW(uchar byte); uchar SPI_RW_Reg(BYTE reg, BYTE value); uchar SPI_Write_Buf(BYTE reg, BYTE *pBuf, BYTE bytes); unsigned char SPI_Read(BYTE reg); u8 SPI_Read_Buf(BYTE reg, BYTE *pBuf, BYTE bytes); void RX_Mode(void); void TX_Mode(void); void nRF24L01_TxPacket(unsigned char * tx_buf); u8 nRF24L01_RxPacket(unsigned char* rx_buf); void nRF24L01_Config(void); void NRF_Receive(void); /************************************************************************ 函数: nRF24L01_Config() 描述:初始化IO *************************************************************************/ void nRF24L01_Config(void) { delay_us(100); CE_L(); // 待机 CSN_H(); // SPI禁止 CE_L(); SPI_RW_Reg(WRITE_REG + CONFIG, 0x0f); SPI_RW_Reg(WRITE_REG + EN_AA, 0x01); SPI_RW_Reg(WRITE_REG + EN_RXADDR, 0x01); // Enable Pipe0 SPI_RW_Reg(WRITE_REG + SETUP_AW, 0x02); // Setup address width=5 bytes SPI_RW_Reg(WRITE_REG + SETUP_RETR, 0x1a); // 500us + 86us, 10 retrans... SPI_RW_Reg(WRITE_REG + RF_CH, 0); SPI_RW_Reg(WRITE_REG + RF_SETUP, 0x07); // TX_PWR:0dBm, Datarate:1Mbps, SPI_RW_Reg(WRITE_REG + RX_PW_P0, RX_PLOAD_WIDTH); SPI_Write_Buf(WRITE_REG + TX_ADDR, TX_ADDRESS, TX_ADR_WIDTH); SPI_Write_Buf(WRITE_REG + RX_ADDR_P0, TX_ADDRESS, TX_ADR_WIDTH); CE_H(); } /**********************************************************************/ uchar SPI_RW(uchar byt