M系列XSCF配置.docVIP

M系列XSCF配置 login: default Change the panel mode switch to Locked and press return… Leave it in that position for at least 5 seconds. Change the panel mode switch to Service, and press return… Check the version of XSCF. XSCF version -c xcp XSCF#0 (Active ) XCP0 (Current): 1090 XCP1 (Reserve): 1090 Create a user xxx XSCF adduser xxx XSCF password password: Permission denied Change the password for xxx XSCF password xxx New XSCF password: Retype new XSCF password: Grant xxx the following privileges, useradm, platadm, aplatop. XSCF setprivileges xxx useradm platadm platop Configure the XSCF interface with an IP address, this will be the adress you connect to via telnet to manage the console. XSCF setnetwork xscf#0-lan#0 -m . 00 Enable the XSCF interface you just configured with an IP address of 00 XSCF setnetwork -c up lan#0 Configure the hostname. XSCF sethostname xscf#0 test Configure the domain name. XSCF sethostname -d You must apply the network configurations with the applynetwork command. XSCF applynetwork The following network settings will be applied: xscf#0 hostname :test DNS domain name : interface : xscf#0-lan#0 status :up IP address :00 netmask : route : interface : xscf#0-lan#1 status :down IP address : netmask : route : Continue? [y|n] :yes Please reset the XSCF by rebootxscf to apply the network settings. Please confirm that the settings have been applied by executing showhostname, shownetwork, showroute and shownameserver after rebooting the XSCF. Now reboot XSCF for the configuration to take effect. XSCF rebootxscf After the reboot check the network settings. XSCF shownetwork -a xscf#0-lan#0 Link encap:Ethernet HWaddr 00:0B:5D:E3:39:B4 inet addr:1 Bcast:55 Mask: UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 RX packets:13160 errors:0 dropped:0 overruns:0 frame:0 TX packets:5 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:1000 RX bytes:1943545 (1.8 MiB) TX bytes:210 (210.0 B) Base address:0xe000 xscf#0-lan#1 Link encap:Ethernet H