FANUC16i 18i 21i硬件连接手册.docVIP

GE Fanuc AutomationComputer Numerical Control ProductsSeries 16i / 18i / 21i / 20i / 160i / 180i / 210i /160is / 180is / 210is - Model AConnection Manual HardwareGFZ-63003EN/04July 2000GFL-001Warnings Cautions and Notesas Used in this PublicationWarningWarning notices are used in this publication to emphasize that hazardous voltages currentstemperatures or other conditions that could cause personal injury exist in this equipment or maybe associated with its use.In situations where inattention could cause either personal injury or damage to equipment aWarning notice is used.CautionCaution notices are used where equipment might be damaged if care is not taken.NoteNotes merely call attention to information that is especially significant to understanding andoperating the equipment.This document is based on information available at the time of its publication. While effortshave been made to be accurate the information contained herein does not purport to cover alldetails or variations in hardware or software nor to provide for every possible contingency inconnection with installation operation or maintenance. Features may be described herein whichare not present in all hardware and software systems. GE Fanuc Automation assumes noobligation of notice to holders of this document with respect to changes subsequently made.GE Fanuc Automation makes no representation or warranty expressed implied or statutorywith respect to and assumes no responsibility for the accuracy completeness sufficiency orusefulness of the information contained herein. No warranties of merchantability or fitness forpurpose shall apply.??Copyright 2000 GE Fanuc Automation North America Inc.All Rights RB–63003EN/04DEFINITION OF WARNING CAUTION AND NOTEs–1DEFINITION OF WARNING CAUTION AND NOTEThis manual includes safety precautions for protecting the user and preventing damage to themachine. Precautions are classified into Warning and Caution according to their bearing on safety.Also supplementary informa