双机提示锁盘丢失解决.docVIP

双机提示锁盘丢失解决 # cmruncl cmruncl: Validating network configuration... cmruncl: Failed to validate the network configuration as reported above but will try to start the cluster anyway. cmruncl: Network validation complete cmruncl: Validating cluster lock disk .../dev/dsk/c2t0d1 is accessible granted to node 1 Failed to check cluster lock disks . Done Waiting for cluster to form ............ # cmapplyconf -v -C /etc/cmcluster/cmclconfig.ascii -P /etc/cmcluster/pkg1/pkg1. conf -P /etc/cmcluster/pkg2/pkg2.conf Begin cluster verification... Checking cluster file: /etc/cmcluster/cmclconfig.ascii Note : a NODE_TIMEOUT value of 2000000 was found in line 134. This value is recommended if the top priority is to reform the cluster as fast as possible in case of failure. If the top priority is to minimize reformations, consider using a higher setting. For more information see the cluster configuration ASCII file or the Managing Serviceguard manual. Checking nodes ... Done Checking existing configuration ... Done Gathering storage information Found 7 devices on node pmosdb1 Found 7 devices on node pmosdb2 Analysis of 14 devices should take approximately 2 seconds 0%----10%----20%----30%----40%----50%----60%----70%----80%----90%----100% Found 4 volume groups on node pmosdb1 Found 4 volume groups on node pmosdb2 Analysis of 8 volume groups should take approximately 1 seconds 0%----10%----20%----30%----40%----50%----60%----70%----80%----90%----100% Gathering network information Beginning network probing (this may take a while) Completed network probing Cluster clusterjy is an existing cluster Parsing package file: /etc/cmcluster/pkg1/pkg1.conf. /etc/cmcluster/pkg1/pkg1.conf: A legacy package is being used. Package pkg1 already exists. It will be modified. WARNING: Incorrect permissions for /etc/cmcluster/pkg1 (40777). Directory must b e